#Lakewood 5500 heater instruction manusl manual
PC Issue 13 August 2015Ĥ Table of Contents 1 Introduction EC Conformity Disclaimer Copyright and trademarks Symbols Safety Failure to comply with safety standards Start up, operation and maintenance Intended conditions of use Safety guidelines relating to maintenance, inspection and assembly work Arbitrary production and transformation of spare parts Chemical Safety Control of Hazardous Substances Hot/Cold Surfaces Hot/Cold Liquids Leakage of hazardous fluids Protective clothing Machine maintenance General Overview Equipment Diagrams HT10XC and accessories Description Overview Modes of Operation Manual Mode Remote Mode Front of Service Unit Rear of Service Unit Installation Advisory Electrical Supply Installing the Software Installing the Equipment Electrical Wiring Diagram Operation Operating the Software Operating the Equipment Setting the Heater Voltage (All accessories except HT17) Measuring the Power to the Heater (All accessories except HT17) Measuring Temperatures (T1 - T10 as appropriate on all accessories) Measuring Thermal Radiation (Radiometer on HT13) Measuring Light Illumination (Lightmeter on HT13) Measuring Air Velocity (Anemometer on HT14, HT14C, HT16, HT16C and HT19) Measuring Cooling Water Flow Rate (Flow sensor on HT11C and HT12C, optional on HT11 and HT12) Operation using customer generated software PC Issue 13 August 2015ĥ Channel allocations Equipment Specifications Overall Dimensions USB Channel Numbers Environmental Conditions Routine Maintenance Responsibility General Fault Finding Thermocouple Calibration Contact Details for Further Information PC Issue 13 August 2015Ħ 3 Disclaimer This document and all the information contained within it are proprietary to Armfield Limited. Emission standard for residential, commercial and lightindustrial environments WARNING - This declaration is only valid if the Equipment is installed, used and maintained in compliance with the above mentioned directives and instructions and with the instructions and equipment described in this manual. Immunity for residential, commercial and light-industrial environments Electromagnetic compatibility (EMC). The equipment has been constructed in compliance with the essential health and safety requirements laid down in the following applicable directives: 2006/95/EC The Low Voltage Directive 2004/108/EC The Electromagnetic Compatibility Directive 2006/42/EC The Machinery Directive PC Issue 13 August 2015ģ The following harmonised standards were also consulted for the design and construction of the equipment: BS EN :2010 Safety requirements for electrical equipment for measurement, control, and laboratory use BS EN :2007 BS EN :2001 Electromagnetic compatibility (EMC).
#Lakewood 5500 heater instruction manusl serial
The declaration of conformity states the model and serial number. WARNING - All practical work areas and laboratories should be covered by local regulations which must be followed at all times 2 EC Conformity Each machine is accompanied by an EC Declaration of Conformity signed by the representative of Armfield Limited. Some of the illustrations in this manual may include parts that are slightly different to those mounted on your machine. WARNING - Armfield Limited reserves the right to modify the specifications referred to in this manual or the characteristics of each machine. This manual contains instructions required for the safety, receiving, installation, storage, correct operation and maintenance of the HT10XC. The manual is an integral part of each piece of equipment and consequently must be kept throughout the entire service life of the machine and accompany it at all times, even if transferred to another user. WARNING - The manufacturer is not liable for consequences resulting from an improper use of the machine due to the user s failure to read this manual or incomplete reading of it. If the manual is lost or damaged contact the manufacturer for a replacement copy. The user manual must be available for ready consultation at all times. The information contained in this manual is intended for the user who is required to read it carefully and to ensure that he has fully understood it before operating the machine. 1 Heat Transfer Service Unit Instruction Manual HT10XC ISSUE 13 August 2015 PCĢ 1 Introduction This manual contains instructions for the correct use and maintenance of the HT10XC manufactured by Armfield Limited.
0 kommentar(er)
